MSD Atomic AirForce LT1 IntakeLooking for increased bolt-on power and torque for that new LT1? MSD is excited to bring out the new polymer Atomic AirForce Intake Manifold perfect for stock and modified direct-injected LT1 applications.

Official Release:

If you’re looking for bolt-on power and torque for your new LT1, the new Atomic AirForce intake manifold from MSD is the answer! This all-new polymer intake will increase the performance of stock and modified versions of the Direct-Injected LT1 engine.

MSD initiated the clean-sheet AirForce design by addressing the performance shortcomings of the OEM manifold. Through the use of Computational Fluid Dynamic modeling, MSD was able to optimize the plenum volume and improve runner layout. Unique bell-mouthed runner openings, optimum runner length, and minimal shrouding ensure maximum airflow and cylinder-to-cylinder balance.

The LT1 intake is a two piece molded design which allows for porting and runner modification, while the polymer construction minimizes the weight and reduces the heat absorption. MSD also makes it easy to accommodate power adders by equipping the AirForce LT1 manifold with integral port fuel injection bosses at the base of each runner.

The AirForce LT1 intake accepts an OEM electronic throttle body, as well as aftermarket electronic throttles up to 105mm.

Features:

  • Dyno-proven bolt-on power – Double-digit Horsepower and torque gains compared to the OE manifold
  • Runner layout and plenum design promotes maximum airflow
  • Two-piece design allows easy access to the both ends of the runners
  • Glass-reinforced composite resists heat soak and minimizes weight
  • Accepts OEM and aftermarket electronic throttle bodies
  • Equipped with port injector bosses to easily accommodate power adders