There are few things more frustrating than a rusty part in your car. Not only does it look bad, but it will eventually be eaten away by that incessant corrosion brought on by oxidation. Luckily, Summit Racing has a solution, Metal Rescue Rust Remover Bath. Metal Rescue is non-corrosive, non-flammable, non-toxic, and biodegradable, yet in as little as four hours, you can expect to have that flywheel or manifold back to a gleaming, clean condition. It works around the clock and doesn’t require any scrubbing or brushing to get the job done, just a quick rinse after the part is done soaking.
The non-corrosive, non-flammable, non-toxic, biodegradable solution that removes rust without damaging paint, chrome, plastic, rubber, or you.
Metal Rescue is a water-based, immersion-bath solution. Fill an appropriately sized plastic container with Metal Rescue and drop in the rusty part(s)—no scrubbing or brushing required. The only condition required is a consistent temperature of 68° F or higher.
Depending on the extent of the corrosion, the de-rusting process can from one to 24 hours; average soak time is four to eight hours. What you get is a completely clean part, ready for use after a quick rinse under the water faucet. Metal Rescue will leave a slightly dull appearance depending on the metal surface, amount of rust, and how long the rust was present.
Metal Rescue is safe for use on painted, anodized, and powdercoated parts. Metal Rescue can also be used on oxidized chrome, aluminum, copper, brass, nickel, and silver as long as you carefully monitor the immersion time to avoid damage.
Metal Rescue can be reused until the solution turns dark and stops working, indicating is has been saturated with rust and can be poured down the drain. If there is any grease, oil, or other chemicals in the solution, Metal Rescue must be disposed of at a proper recycling facility. Part numbers are as follows: APP-1812290497 (1 quart), APP-1812290487 (1 gallon), and APP-0510570295 (5 gallons).
- Restores rusty parts to a pristine clean in as little as four hours
- No scrubbing or brushing required
- Safe for use on painted, anodized, powdercoated parts; also, chrome, aluminum, copper, brass, nickel, and silver
- Non-corrosive, non-flammable, non-toxic, and biodegradable